Most of my Sharpap runs are not limited by time but by the height of my horizon. I have my 360 degree horizon mapped so I know how low I can go at any given degree setting.
When I write a Sharpcap sequence I always have to go to Stellarium and move the clock forward until the object that I am imaging reaches it's mninimum degree of altitude. then plug in tht time limit.
I am sure there are a lot of people that find themselves having to do this.
It would be nice to have a Sequence command that did a "STOP AT (degree) ABOVE HORIZON". I could just plug in my degree limit and not have to change the run if I use for more tha a week or two.
Thanks for consideration.
A quick note on STOP AT
- admin
- Site Admin
- Posts: 17573
- Joined: Sat Feb 11, 2017 3:52 pm
- Location: Vale of the White Horse, UK
- Contact:
Re: A quick note on STOP AT
Hi,
check the Advanced tab of the sequencer and look for 'Stop running these steps when <degrees> above the horizon'.
On the to-do list at some point is to add functionality for a variable height horizon ...
cheers,
Robin
check the Advanced tab of the sequencer and look for 'Stop running these steps when <degrees> above the horizon'.
On the to-do list at some point is to add functionality for a variable height horizon ...
cheers,
Robin
Re: A quick note on STOP AT
Thanks Robin, I missed it