A quick note on STOP AT

Anything that doesn't fit into any of the other forums
Post Reply
yomamma
Posts: 105
Joined: Wed Mar 01, 2023 4:58 pm

A quick note on STOP AT

#1

Post by yomamma »

Most of my Sharpap runs are not limited by time but by the height of my horizon. I have my 360 degree horizon mapped so I know how low I can go at any given degree setting.

When I write a Sharpcap sequence I always have to go to Stellarium and move the clock forward until the object that I am imaging reaches it's mninimum degree of altitude. then plug in tht time limit.

I am sure there are a lot of people that find themselves having to do this.

It would be nice to have a Sequence command that did a "STOP AT (degree) ABOVE HORIZON". I could just plug in my degree limit and not have to change the run if I use for more tha a week or two.

Thanks for consideration.
User avatar
admin
Site Admin
Posts: 17573
Joined: Sat Feb 11, 2017 3:52 pm
Location: Vale of the White Horse, UK
Contact:

Re: A quick note on STOP AT

#2

Post by admin »

Hi,

check the Advanced tab of the sequencer and look for 'Stop running these steps when <degrees> above the horizon'. :)

On the to-do list at some point is to add functionality for a variable height horizon ...

cheers,

Robin
yomamma
Posts: 105
Joined: Wed Mar 01, 2023 4:58 pm

Re: A quick note on STOP AT

#3

Post by yomamma »

Thanks Robin, I missed it
Post Reply