Page 1 of 1

Using the Cover Calibrator commands

Posted: Tue Jun 02, 2026 3:02 am
by yomamma
I want to automate my flats for a remote site and I have an Alnitak on my refractor.
When you issue the command to open or close the cover, does the calling process wait until a "process complete" is received from the Alnitak before the program resumes execution? Was not sure If I needed to wait nn seconds before proceeding.
Thanks

Re: Using the Cover Calibrator commands

Posted: Tue Jun 02, 2026 12:44 pm
by admin
Hi,

if you are using the sequencer step 'Open the cover/calibrator device' then it will wait until the cover reports its state as 'open' before the sequence finishes that step and moves on. There is also a time limit of 60s on the open operation (and close too) - if it takes longer than that, SharpCap will assume that something has gone wrong.

cheers,

Robin