My meridian flip did not flip
Posted: Mon Mar 17, 2025 2:49 pm
I program my own meridian flips by stopping just before the meridian and then waiting until the object 5-10 degrees past the meridian then I goto and platesolve on the other side then continue imaging. All my scripts are setup this way.
I just bought a new mount, WarpAstron WD20, and I have programmed the driver to allow the telescope to go beyond the meridian from east to west(pier west) by 5 degrees. So if I had weights on the mount it would be slightly weights up at that point.
I did a run last night and only waited until the object was 4.5 degrees past the meridian rather than a full 5 degrees before I started back up. I ran the goto but the mount did not flip.
My question is do you think the mount did not flip because I had set the -5 degree limit beyond the meridian and I was only -4.5 degrees when I executed the goto?
It is the only thing I can think of because these runs have worked on my EQ6R Pro but I have the limit set to 0 there. Will change the limit and try again tonight.
Thanks for any input.
I just bought a new mount, WarpAstron WD20, and I have programmed the driver to allow the telescope to go beyond the meridian from east to west(pier west) by 5 degrees. So if I had weights on the mount it would be slightly weights up at that point.
I did a run last night and only waited until the object was 4.5 degrees past the meridian rather than a full 5 degrees before I started back up. I ran the goto but the mount did not flip.
My question is do you think the mount did not flip because I had set the -5 degree limit beyond the meridian and I was only -4.5 degrees when I executed the goto?
It is the only thing I can think of because these runs have worked on my EQ6R Pro but I have the limit set to 0 there. Will change the limit and try again tonight.
Thanks for any input.