I program my own meridian flips by stopping just before the meridian and then waiting until the object 5-10 degrees past the meridian then I goto and platesolve on the other side then continue imaging. All my scripts are setup this way.
I just bought a new mount, WarpAstron WD20, and I have programmed the driver to allow the telescope to go beyond the meridian from east to west(pier west) by 5 degrees. So if I had weights on the mount it would be slightly weights up at that point.
I did a run last night and only waited until the object was 4.5 degrees past the meridian rather than a full 5 degrees before I started back up. I ran the goto but the mount did not flip.
My question is do you think the mount did not flip because I had set the -5 degree limit beyond the meridian and I was only -4.5 degrees when I executed the goto?
It is the only thing I can think of because these runs have worked on my EQ6R Pro but I have the limit set to 0 there. Will change the limit and try again tonight.
Thanks for any input.
My meridian flip did not flip
- admin
- Site Admin
- Posts: 17580
- Joined: Sat Feb 11, 2017 3:52 pm
- Location: Vale of the White Horse, UK
- Contact:
Re: My meridian flip did not flip
Hi,
the exact behaviour of how a mount handles the side of pier on a GOTO like the one you are describing can vary - depending on how the developers of the mount/ASCOM driver have decided their hardware should behave.
It would be possible to set up the hardware so that it would track for 5 degrees past the meridian but when asked to GOTO in that region it would flip before doing the GOTO. It would also be possible to have it so that it wouldn't do the flip on GOTO until *more* than 5 degrees past. I would certainly try setting things up so that the GOTO waits until the mount is more than 5 degrees past the meridian - hopefully that will be enough. For some mounts it is also possible to manually request the mount to flip sides - the 'Meridian Flip the mount' step in the sequencer will attempt to use that approach if the mount supports it.
cheers,
Robin
the exact behaviour of how a mount handles the side of pier on a GOTO like the one you are describing can vary - depending on how the developers of the mount/ASCOM driver have decided their hardware should behave.
It would be possible to set up the hardware so that it would track for 5 degrees past the meridian but when asked to GOTO in that region it would flip before doing the GOTO. It would also be possible to have it so that it wouldn't do the flip on GOTO until *more* than 5 degrees past. I would certainly try setting things up so that the GOTO waits until the mount is more than 5 degrees past the meridian - hopefully that will be enough. For some mounts it is also possible to manually request the mount to flip sides - the 'Meridian Flip the mount' step in the sequencer will attempt to use that approach if the mount supports it.
cheers,
Robin