Hello,
Just wondering what I might be doing to cause the appearance of what I can only describe as 'margin creep'/overlapping 'frames’ onscreen while live stacking (see phone camera shot of screen from last night). I was shooting 60sec subs @ 300 gain with a Newtonian 150/1200/Svbony705C and guiding with a ST80/400 and Touptek678M, dithering every 120 sec. This phenomenon became evident after 15 mins or so with a margin creep from three sides and the appearance of uneven stacking of frames. In these ‘margins', it seemed as if there was no noise present. There were no obvious issues with alignment across the whole screen. After 30 minutes or so it seemed to stabilise, i.e. didn't evolve more.
Afterwards I switched to 10sec subs @500 gain and stopped guiding/dithering and the problem didn't manifest. Just loads of streaky walking noise when I checked the stack after an hour or so.
Anyone any pointers as to what I should be doing/ not doing to avoid this phenomenon.
Thanking you.
'Margin creep'
'Margin creep'
- Attachments
-
- 20250526_234156.jpg (808.08 KiB) Viewed 2747 times
Re: 'Margin creep'
It looks as though you have quite a narrow field there at a long focus and the accuracy of polar alignment, levelling the mount etc would have to be very good for the field not to shift a bit with or without guiding - and of course if the dither size is too large (measured in guide scope plus camera pixels) it could chop off a lot of the edge. I always see drift and when it gets too much I just plate solve again. SC can also be set to do this automatically I believe. Tim
- admin
- Site Admin
- Posts: 17580
- Joined: Sat Feb 11, 2017 3:52 pm
- Location: Vale of the White Horse, UK
- Contact:
Re: 'Margin creep'
Hi,
Tim is right - the image coming from the camera has shifted due to the mount tracking being slightly off. As that shift build up over time, some areas on the edge of the image no longer receive data and start to go darker when in the 'default' stacking mode.
Sigma clipped stacking mode is normally not really affected by this as the drifted out area produces zero value pixels which are then excluded by the sigma clipping check, so the borders will not go dark. The noise levels in those regions will no longer decrease to match the rest of the stack however, since no new data is being added.
You can also consider guiding to keep the telescope on target (requires additional hardware) or, if you have a GOTO telescope and plate solving set up, you can use the 'Recenter' option in the live stacking guiding tab - that can use your GOTO mount to correct the position each time the drift reaches a threshold level.
cheers,
Robin
Tim is right - the image coming from the camera has shifted due to the mount tracking being slightly off. As that shift build up over time, some areas on the edge of the image no longer receive data and start to go darker when in the 'default' stacking mode.
Sigma clipped stacking mode is normally not really affected by this as the drifted out area produces zero value pixels which are then excluded by the sigma clipping check, so the borders will not go dark. The noise levels in those regions will no longer decrease to match the rest of the stack however, since no new data is being added.
You can also consider guiding to keep the telescope on target (requires additional hardware) or, if you have a GOTO telescope and plate solving set up, you can use the 'Recenter' option in the live stacking guiding tab - that can use your GOTO mount to correct the position each time the drift reaches a threshold level.
cheers,
Robin
Re: 'Margin creep'
Many thanks Tim and Robin. I'll follow your advice in the coming nights.