not sure if bug or not? ASCOM + Compustar issues with MoveAxis

Anything that doesn't fit into any of the other forums
Post Reply
Phoenix
Posts: 16
Joined: Sat May 03, 2025 9:25 pm

not sure if bug or not? ASCOM + Compustar issues with MoveAxis

#1

Post by Phoenix »

Im trying to use my C8 CST with sharpcap so i can take some mosaics. Ive had this telescope since i was 16, after working for 2 years to buy it for $16,000. so its got a certain familiarity and nostalgia to it, on top of still being a fantastic scope thanks to angelo's y2k & ascom update.

when i use the ascom panel to connect to the scope, i get a moveaxis dialog which i can press buttons and move the scope around just fine. when i connect via SharpCap, i get the error that the moveaxis isn't supported, yet the control panel pops up and i can still move the scope using the buttons.

I'm not sure whats going on here, but I'm pretty bummed about it. Ive unpacked this scope after a couple of decades in storage due to the y2k bug it had, and the fact i was sick of freezing for hours hand guiding plate photography. buying a new imager and updating the firmware has reignited a hobby that i left behind for 20 years, especially my interest in solar photography.

But without the ability to mosaic, i cant capture the entire disk. :-(

help?!
User avatar
admin
Site Admin
Posts: 17584
Joined: Sat Feb 11, 2017 3:52 pm
Location: Vale of the White Horse, UK
Contact:

Re: not sure if bug or not? ASCOM + Compustar issues with MoveAxis

#2

Post by admin »

Hi,

I had to go and read up about the Compustar system - I hadn't encountered it or heard about it before now! Amazing to think of that sort of functionality being available back in the 1980s :)

I'm assuming that you are using the ASCOM driver that is available for the Compustar from this web site : https://www.aemfoto.it/wp/2017/12/28/an ... compustar/ - or at least something similar. I downloaded the software from that site and checked which features of ASCOM are supported by the driver, and it does look like the 'MoveAxis' ASCOM command is not supported - this means that applications like SharpCap cannot give working directional buttons.

It also looks as though the control panel that is part of the ASCOM driver *does* have movement buttons that work, which lets us know that the underlying capability of telling the mount to move is there.

Making this work is something that would need to be implemented by the person who is writing that ASCOM driver for the Compustar - they would need to create a new version that implements MoveAxis (and also the mechanisms for SharpCap to query which movement rates are supported). Unfortunately this isn't something that I can add from the SharpCap side.

cheers,

Robin
Post Reply