flats, dark flats, and flat bias frames

Anything that doesn't fit into any of the other forums
Post Reply
jpiquette
Posts: 16
Joined: Thu May 12, 2022 5:33 pm

flats, dark flats, and flat bias frames

#1

Post by jpiquette »

Should all 3 of the subject calibration frames be done using the same exposure? I am pretty sure at least flats and dark flats should be. Not sure about the flat bias frames.

What is confusing is that when I capture flats and flat bias using SharpCap, the exposure time I have set for the flats gets set down to 1 ms by SHarpCap when the flat bias frames are captured. Then when I cover the aperture to get the flat darks, I have been still using the 1ms exposure time that the software has set when it captured the flat bias frames.

Pretty sure this is is a mistake. If the 1 ms exposure set by the SharpCap software is good for the flat bias frames, it looks like when I move on to get the flat darks I need to set the exposure back to what I had set when I did the flats. Is that correct?

And is the 1 ms exposure that the software has set for the flat bias frames a good exposure time? Or should I set that to the same exposure time also that I have used to capture the flats?

Jean
User avatar
admin
Site Admin
Posts: 17584
Joined: Sat Feb 11, 2017 3:52 pm
Location: Vale of the White Horse, UK
Contact:

Re: flats, dark flats, and flat bias frames

#2

Post by admin »

Hi Jean,

when you are capturing flats in SharpCap, it should be *either* dark flats (same exposure as flats, but cover aperture) or bias frames (short 1ms exposure, no need to cover aperture provided the frame goes substantially dark). It should not be both (there is no need and SharpCap's processing is not set up to take account of both). You should not be able to persuade the program to do both in the same 'Capture Flat' run.

The choice between the two is generally made based on the exposure you are using to take the flat frames:

* Long exposures (more than 1 or 2s) - you should use the dark flat option
* Very short exposures (less than about 10ms) - you should also use the dark flat option
* Middle exposures - about 10ms to about 2s - using the bias option should be fine and is easier (no need to cover/uncover).

cheers,

Robin
Post Reply