When my sequencer requests a dither to PHD2 using the "request a single dither" command does the Sequencer wait for a "settled" response before moving on to the next command in the sequencer or should I place a wait nn seconds after the dither to accommodate settling?
Thanks for your help.
Does Sharpcap wait for "settled" response after dither request?
-
admin
- Site Admin
- Posts: 17558
- Joined: Sat Feb 11, 2017 3:52 pm
- Location: Vale of the White Horse, UK
- Contact:
Re: Does Sharpcap wait for "settled" response after dither request?
Hi,
it should, but looking at the code to check this, I noticed that it's possible that it checks the state so quickly after the dither request that it might not even have noticed that the dither has started at that point. I will add a delay there to wait a couple of seconds before it starts monitoring to see if the dither has settled which should eliminate the chance of that happening.
cheers,
Robin
it should, but looking at the code to check this, I noticed that it's possible that it checks the state so quickly after the dither request that it might not even have noticed that the dither has started at that point. I will add a delay there to wait a couple of seconds before it starts monitoring to see if the dither has settled which should eliminate the chance of that happening.
cheers,
Robin