Hi,
When I go to plate solve after a slew, I often, perhaps always, notice the phrase: "down sampling by 2". Could someone please explain what this means and whether I may need to change the default Astrotortilla UI settings. I've seen posts that outline custom settings to enter into Astrotortilla but I have never changed the defaults except to limit solution attempts to a 15 degree radius since SC declares failure if the slew is more than that far off.
Thank you for any help and advice you can offer. I'm just hoping to better understand the plate solving process that goes on.
Gary
Plate Solving - Quick Question
- admin
- Site Admin
- Posts: 17576
- Joined: Sat Feb 11, 2017 3:52 pm
- Location: Vale of the White Horse, UK
- Contact:
Re: Plate Solving - Quick Question
Hi,
experience has helped us understand that the engine used for plate solving in AstroTortilla, ASPS and AnSvr is actually not very good for very high resolution images for some reason. In order to improve the reliability of plate solving SharpCap will ask the engine to reduce the resolution if the image width exceeds (from memory) 2000 pixels. This is basically equivalent to binning the image – with the binning factor chosen depending on the width and height of the image in pixels.
Cheers, Robin
experience has helped us understand that the engine used for plate solving in AstroTortilla, ASPS and AnSvr is actually not very good for very high resolution images for some reason. In order to improve the reliability of plate solving SharpCap will ask the engine to reduce the resolution if the image width exceeds (from memory) 2000 pixels. This is basically equivalent to binning the image – with the binning factor chosen depending on the width and height of the image in pixels.
Cheers, Robin
Re: Plate Solving - Quick Question
Ok Robin thank you. Since the solver is solving based on stars, what ‘image’ is the binning being based on?