issue with camera general setting and touptek
Posted: Wed Oct 14, 2026 7:58 pm
Hi Robin,
it seems to me that when we activate the option for Touptek in camera settings to allow manual control of conversion gain via read mode , the histogram helper does not use the correct sensor analysis , in my example (I have a 2600M) I was set on LCG and it was using HCG sensor data or something else (maybe the ATR585M I was using before). It did not take the 2600M 16 bit low level noise I was expected. Disabling the option in camera setting and restarting SC did the job and I got then the correct sensor analysis. I have already seen that behaviour in SC 4.1
Kind regards
Olivier
it seems to me that when we activate the option for Touptek in camera settings to allow manual control of conversion gain via read mode , the histogram helper does not use the correct sensor analysis , in my example (I have a 2600M) I was set on LCG and it was using HCG sensor data or something else (maybe the ATR585M I was using before). It did not take the 2600M 16 bit low level noise I was expected. Disabling the option in camera setting and restarting SC did the job and I got then the correct sensor analysis. I have already seen that behaviour in SC 4.1
Kind regards
Olivier