Page 1 of 1
My auto focus almost never fails
Posted: Sat Feb 21, 2026 12:16 am
by yomamma
I have noticed recently that my auto focus routines are working well and really never fail as I have a retry 3 times on it and if the first time fails the second try always works. This is not my recollection say from maybe earlier last year(??).
Have there been any changes/improvements to the focus routine recently? When my C11 SCT begins to auto focus in bad seeing something is up. I am not complaining at all just noting that auto focus seems to work a lot better than before and I really like it.
Re: My auto focus almost never fails
Posted: Sat Feb 21, 2026 1:29 pm
by admin
Hi,
the autofocus is something that I have been gradually improving over time in a few different ways... If you are talking about planetary autofocus then I did some significant work about a year ago trying to optimize how the measurements of focus quality were made to increase the sensitivity of the detection of good focus.
Also, for all focus methods I have been slowly improving how the detection of the curve works - how it deals with perhaps a bad data point in the middle of an otherwise good curve, how it decides whether a curve is a significant curve showing where best focus is or just a set of random values with no real pattern, etc.
My own use of autofocus now suggests that it is pretty much solid for focus based on star FWHM (multi star FWHM is best). For planetary, the defaults work well unless the seeing is highly variable (if the seeing is oscillating between good and bad then that can really throw it out).
Glad to hear that it is working well anyway
cheers,
Robin
Re: My auto focus almost never fails
Posted: Sat Feb 21, 2026 1:58 pm
by yomamma
I have noticed that getting one 25.00 on your focus scan in the past, usually in the beginning or end of the scan, would usually kill the focus run but now when the routine realizes the beginning anomaly he ignores it which is where I would have the problem. Thanks for making it work so well.
Re: My auto focus almost never fails
Posted: Mon Feb 23, 2026 2:00 pm
by admin
Hi,
yes, the '25' is an artifically high value that gets generated when there are no stars (or too few stars). That gives something to plot on the graph, but the code needs to ignore those values for curve fitting and it now does
cheers,
Robin