Canon DSLR Polar Alignment FOV
Posted: Sun Dec 28, 2025 7:45 pm
I want to do some shooting with my Canon DSLR for DSOs, and want to do the polar alignment with my Canon DSLR rather than switching up between my dedicated planetary astrocam then to the DSLR as will take longer, also focusing twice etc.
I'm using my Canons Mini-HDMI port with a video capture converter to "stream"/output it onto my laptop. SharpCap recognises it (Cameras < USB3.0 Capture) without any additional drivers etc just plug and play.
Only issue now is the FOV. Current setup i.e. not using a lens but a small guide scope (Svbony SV106 i.e. 60mm/240mm) with my Canon DSLR brings the FOV to 5.33° x 3.55°. This is based on https://astronomy.tools/calculators/field_of_view/ Canon EOS 100D selection and my guide scope. Resolution shown being 5196.00px x 3464.00px.
I have read that if I use a smaller ROI, I can bring the FOV down/adjust it? I however don't see any ROI control on SharpCap for my Canon DSLR, I do have this option with my dedicated planetary astrocam though.
I have the ability to change the resolution via SharpCap though, would that work? I.e. alter my FOV? I am also not sure why SharpCap doesn't show my full resolution (5196.00px x 3464.00px)? It's capped at 1920 x 1080?
These are the options I have screenshotted linked below:

At the current resolution set at 1920 x 1080 if this affects the FOV, it should be 1.97° x 1.11° this would be well within the bounds necessary i.e. 1-2.5 degrees.
Am I correct or missing something?
I'm using my Canons Mini-HDMI port with a video capture converter to "stream"/output it onto my laptop. SharpCap recognises it (Cameras < USB3.0 Capture) without any additional drivers etc just plug and play.
Only issue now is the FOV. Current setup i.e. not using a lens but a small guide scope (Svbony SV106 i.e. 60mm/240mm) with my Canon DSLR brings the FOV to 5.33° x 3.55°. This is based on https://astronomy.tools/calculators/field_of_view/ Canon EOS 100D selection and my guide scope. Resolution shown being 5196.00px x 3464.00px.
I have read that if I use a smaller ROI, I can bring the FOV down/adjust it? I however don't see any ROI control on SharpCap for my Canon DSLR, I do have this option with my dedicated planetary astrocam though.
I have the ability to change the resolution via SharpCap though, would that work? I.e. alter my FOV? I am also not sure why SharpCap doesn't show my full resolution (5196.00px x 3464.00px)? It's capped at 1920 x 1080?
These are the options I have screenshotted linked below:
At the current resolution set at 1920 x 1080 if this affects the FOV, it should be 1.97° x 1.11° this would be well within the bounds necessary i.e. 1-2.5 degrees.
Am I correct or missing something?