Page 1 of 1

Dual Monitor & Live Stacking Panel

Posted: Sun Dec 14, 2025 5:06 pm
by AstroChessPilot
Hello Robin,

I think this was discussed once, but I'm sorry I could not find the thread.

Is there a was to inhibit the Live Stacking panel from fully expanding when toggling two monitor view?

When engaging the dual monitor view, the live stacking panel on monitor one almost full expands shrinking the preview image very small. I have to resize the live stacking panel back down to its original position after selecting dual monitors. On the second monitor, I often zoom in on the object but want to still have a large enough preview image on the first monitor to catch those pesky Starlink trails or an airplane so I can unstack them. I however switch back and forth several times during a live stack from single monitor to dual monitor to view other programs on the second monitor (PHD2, CdC). This switching of monitor modes makes it a little inconvenient to keep resizing the live stacking panel each time. I noticed that the Histogram and Focus Assistant panels do not exhibit this behavior.

I have attached an image illustrating the issue.

Thanks,

Tom
SC.jpg
SC.jpg (966.99 KiB) Viewed 784 times

Re: Dual Monitor & Live Stacking Panel

Posted: Mon Dec 15, 2025 1:52 pm
by admin
Hi,

right now the only thing you can do is switch into two monitor view before you activate live stacking. If you do it in that order, the control area doesn't change at all, so you get the normal height live panel area. By taking that approach, you could (for instance) resize the live stack panel to about 1/2 height to get two rows, then that will be remembered by SharpCap.

I suppose I could make it remember the adjusted height separately for two monitor view - that might work.

cheers,

Robin

Re: Dual Monitor & Live Stacking Panel

Posted: Mon Dec 15, 2025 9:00 pm
by AstroChessPilot
Thanks Robin, I tried selecting dual monitors first and it worked as you described. However, even running that procedure, if I close the second monitor view and the re-select two monitor view during the same live stack, it reverts back to the fully expanded live stack pane..

Re: Dual Monitor & Live Stacking Panel

Posted: Tue Dec 16, 2025 2:38 pm
by admin
Hi,

yes, you are right - the height change is triggered by two monitor view with live stack active. Really it should be consistent and be triggered either way around (whichever first), and should remember. When I get a chance I will do that.

cheers,

Robin

Re: Dual Monitor & Live Stacking Panel

Posted: Wed Dec 17, 2025 1:00 pm
by AstroChessPilot
Thanks so much, this will be greatly appreciated!