Deepsky imaging with new kit
Posted: Fri Nov 14, 2025 1:51 pm
I have recently purchased new telescope that will require me to use PHD2 and will be utilising the plate solving capabilities using ASTAP in Sharpcap. I have configured already Sharpcap to talk to PHD2 and setup the platesolving side of things. The process of me getting images will change to how I used to do it using Celestron software but would I be correct in saying the following steps to getting to a target using my new equipment ready for imaging would be:
1. Connect PHD2 to devices
2. Polar align
3. Use Sharpcap to goto to target from catalog
4. Get PHD2 to select a star and ensure it is guiding and then minimize
5. In SharpCap do platesolve to centre target and do fine tuning if required.
6. Once happy with target being framed correctly go to PHD2 to check guiding is on track and start imaging if all ok
1. Connect PHD2 to devices
2. Polar align
3. Use Sharpcap to goto to target from catalog
4. Get PHD2 to select a star and ensure it is guiding and then minimize
5. In SharpCap do platesolve to centre target and do fine tuning if required.
6. Once happy with target being framed correctly go to PHD2 to check guiding is on track and start imaging if all ok