A quick note on STOP AT
Posted: Fri Oct 31, 2025 7:21 pm
Most of my Sharpap runs are not limited by time but by the height of my horizon. I have my 360 degree horizon mapped so I know how low I can go at any given degree setting.
When I write a Sharpcap sequence I always have to go to Stellarium and move the clock forward until the object that I am imaging reaches it's mninimum degree of altitude. then plug in tht time limit.
I am sure there are a lot of people that find themselves having to do this.
It would be nice to have a Sequence command that did a "STOP AT (degree) ABOVE HORIZON". I could just plug in my degree limit and not have to change the run if I use for more tha a week or two.
Thanks for consideration.
When I write a Sharpcap sequence I always have to go to Stellarium and move the clock forward until the object that I am imaging reaches it's mninimum degree of altitude. then plug in tht time limit.
I am sure there are a lot of people that find themselves having to do this.
It would be nice to have a Sequence command that did a "STOP AT (degree) ABOVE HORIZON". I could just plug in my degree limit and not have to change the run if I use for more tha a week or two.
Thanks for consideration.