Page 1 of 1

Bahtinov Focusing Tool

Posted: Sun Aug 17, 2025 7:05 pm
by sandconp
I have been using the Bahtinov Mask tool to focus for a number of years and it's been working great. A few weeks ago, I tried using it and I kept getting this message I haven't seen before.

3 Lines Detected, but not at evenly spaced angles.

I did a google search and it mentioned that I wasn't in focus. Well, that's the whole point to use the tool to get to focus. I know that I might be off a bit but I believe I was close to focus.

What do I need to do to get this working again?

Re: Bahtinov Focusing Tool

Posted: Mon Aug 18, 2025 3:33 pm
by admin
Hi,

in a typical bahtinov mask image, you have three lines, and the two diagonal lines are opposite sides of the middle line, but equal angles away from it on the two sides, like this
image283.jpg
image283.jpg (2.09 KiB) Viewed 494 times
When you are out of focus, the middle line shifts a bit sideways so that the three do not meet at a point, but the angles stay the same.

SharpCap is looking for that pattern of a middle line with two diagonal lines crossing it, and the angles from the middle line to the diagonal lines are roughly the same. The message you are getting indicates that SharpCap is finding the angle on one side is quite different from the angle on the other, so it can't properly interpret the bahtinov mask pattern.

I suspect that the most likely cause for this is that SharpCap is not picking up the bahtinov lines properly - you can tell if this is a problem - check to see if the overlay lines that SharpCap is adding follow the actual lines in the image properly. If you don't the best things to do are to try adjusting the bahtinov mask detection settings to get those overlay lines to properly follow the bright lines in the image. In particular, check the 'Black Threshold' adjustment, which should be set so that all of the image outside the bright lines is shaded out. Other adjustments such as the line width may help.

Once you have the overlay lines following the actual light pattern, hopefully everything will work. If not, use the 'Snapshot' button to save an image and then share it here for further investigation.

cheers,

Robin