SharpCap Forums

Hi Robin,
I just installed the July 15 software update and noticed the Multi Column check box in the Camera Control header. I really like this feature but noticed that some of the info on the right most column near the edge of the display is cut off. I have a 24" monitor if that matters. Thought I'd let you know.

Thanks
Dave

Hi Dave,

you need to make the right hand control area wider to avoid that - in normal mode, the 'overflow' if there isn't enough space happens by allowing you to scroll vertically. When you go into multi column mode, the overflow changes - it happens by allowing you to scroll horizontally if there isn't enough space to show all the columns that are needed. There is also a minimum column width, so if the controls you have will not fit into 1 column, you will get 2 columns of the minimum width, which could be wider than the space you have allowed.

cheers,

Robin