Page 1 of 1

Plate solving- lx200 12" with ASI585MC

Posted: Thu Jun 12, 2025 1:42 am
by geoscoping
Hello,

I have what I hope is a quick and easy question.

I have a LX200GPS 12" scope with a ASI120mm Guide scope using a 32mm aperture and I will be getting a ASI585MC camera. For the scope I also have a F6.3 reducer installed. So my question is, which one would be best for plate solving?

Re: Plate solving- lx200 12" with ASI585MC

Posted: Thu Jun 12, 2025 1:08 pm
by admin
Hi,

the wider field of view of the guide scope will plate solve more quickly and easily than the narrow one of the main scope, but if you do it that way then you have to get the guide scope aligned with the main scope (otherwise you will get the target in view of the guide scope, but it will still be out of view of the main scope). If you have a permanent setup then that's not too bad as you need to align the two scopes once. If you have to take your equipment outside and re-set up for each session then it's not ideal.

Your main scope, with the 0.63x reducer and IMX585 camera is going to be on the edge of reliable plate solving using SharpCap's built in solver (SharpSolve). The Field of view calculator (https://astronomy.tools/calculators/field_of_view/) comes up with 0.34 by 0.19 degrees. Ideally it should be above 0.25 degrees in each direction for SharpSolve, but you will probably find it works most of the time with your FOV (you will need to download/install the larger star database though - from the Plate Solve settings).

Hope this helps,

Robin

Re: Plate solving- lx200 12" with ASI585MC

Posted: Thu Jun 12, 2025 2:19 pm
by geoscoping
The larger database you're referring to is the index download in the plate solving settings? The one you need to download in order to use the narrower FOV? I think it's 15 degrees. I'm not at my computer at the moment.

Re: Plate solving- lx200 12" with ASI585MC

Posted: Fri Jun 13, 2025 12:49 pm
by admin
Hi,

you need to use the button highlighted with the red arrow below, after which you will be able to select the smaller 0.25 degree FOV option. I think that with the 15 degrees you are referring to the search radius (blue highlight), which is different - that controls how far out from the estimated position SharpCap will search when trying to plate solve.

cheers,

Robin
Screenshot 2025-06-13 134732.jpg
Screenshot 2025-06-13 134732.jpg (169.28 KiB) Viewed 2768 times

Re: Plate solving- lx200 12" with ASI585MC

Posted: Fri Jun 13, 2025 9:01 pm
by geoscoping
Okay thank you very much! I thought that was what you were referring to I just couldn't remember the exact degree on the settings

Re: Plate solving- lx200 12" with ASI585MC

Posted: Sat Jun 14, 2025 10:48 am
by Menno555
As extra tip: when using the build-in SharpCap solving engine, the setting for Focal Length can be set to Do not use.
The time it takes to solve is already fast plus this way you always get the right result when using a reducer or Barlow or use another camera.

Menno

Re: Plate solving- lx200 12" with ASI585MC

Posted: Sat Jun 14, 2025 7:10 pm
by geoscoping
thats a big help! I'll be trying that!