'Margin creep'
Posted: Tue May 27, 2025 4:47 pm
Hello,
Just wondering what I might be doing to cause the appearance of what I can only describe as 'margin creep'/overlapping 'frames’ onscreen while live stacking (see phone camera shot of screen from last night). I was shooting 60sec subs @ 300 gain with a Newtonian 150/1200/Svbony705C and guiding with a ST80/400 and Touptek678M, dithering every 120 sec. This phenomenon became evident after 15 mins or so with a margin creep from three sides and the appearance of uneven stacking of frames. In these ‘margins', it seemed as if there was no noise present. There were no obvious issues with alignment across the whole screen. After 30 minutes or so it seemed to stabilise, i.e. didn't evolve more.
Afterwards I switched to 10sec subs @500 gain and stopped guiding/dithering and the problem didn't manifest. Just loads of streaky walking noise when I checked the stack after an hour or so.
Anyone any pointers as to what I should be doing/ not doing to avoid this phenomenon.
Thanking you.
Just wondering what I might be doing to cause the appearance of what I can only describe as 'margin creep'/overlapping 'frames’ onscreen while live stacking (see phone camera shot of screen from last night). I was shooting 60sec subs @ 300 gain with a Newtonian 150/1200/Svbony705C and guiding with a ST80/400 and Touptek678M, dithering every 120 sec. This phenomenon became evident after 15 mins or so with a margin creep from three sides and the appearance of uneven stacking of frames. In these ‘margins', it seemed as if there was no noise present. There were no obvious issues with alignment across the whole screen. After 30 minutes or so it seemed to stabilise, i.e. didn't evolve more.
Afterwards I switched to 10sec subs @500 gain and stopped guiding/dithering and the problem didn't manifest. Just loads of streaky walking noise when I checked the stack after an hour or so.
Anyone any pointers as to what I should be doing/ not doing to avoid this phenomenon.
Thanking you.