flats, dark flats, and flat bias frames
Posted: Sun Apr 27, 2025 5:59 pm
Should all 3 of the subject calibration frames be done using the same exposure? I am pretty sure at least flats and dark flats should be. Not sure about the flat bias frames.
What is confusing is that when I capture flats and flat bias using SharpCap, the exposure time I have set for the flats gets set down to 1 ms by SHarpCap when the flat bias frames are captured. Then when I cover the aperture to get the flat darks, I have been still using the 1ms exposure time that the software has set when it captured the flat bias frames.
Pretty sure this is is a mistake. If the 1 ms exposure set by the SharpCap software is good for the flat bias frames, it looks like when I move on to get the flat darks I need to set the exposure back to what I had set when I did the flats. Is that correct?
And is the 1 ms exposure that the software has set for the flat bias frames a good exposure time? Or should I set that to the same exposure time also that I have used to capture the flats?
Jean
What is confusing is that when I capture flats and flat bias using SharpCap, the exposure time I have set for the flats gets set down to 1 ms by SHarpCap when the flat bias frames are captured. Then when I cover the aperture to get the flat darks, I have been still using the 1ms exposure time that the software has set when it captured the flat bias frames.
Pretty sure this is is a mistake. If the 1 ms exposure set by the SharpCap software is good for the flat bias frames, it looks like when I move on to get the flat darks I need to set the exposure back to what I had set when I did the flats. Is that correct?
And is the 1 ms exposure that the software has set for the flat bias frames a good exposure time? Or should I set that to the same exposure time also that I have used to capture the flats?
Jean