Page 1 of 1

PHD2 says is guiding but Sharpcap says paused

Posted: Fri Apr 18, 2025 12:35 pm
by yomamma
I have included a link to the log file.

At 1:31 am I did a manual meridian flip. At 3 degrees prior I stopped and waited until 1:31 which put my object 5 degrees past the meridian and would hopefully find it and platesolve.

That worked and PHD2 started guiding again but Sharpcap thought is was paused. I used the Pause guiding until this block finishes and it looks as though it worked in the log file(no error) but from that point forward it thought PHD2 was not guiding but paused. When I look at the PHD2 graph it was guiding pretty well but there were no dithers so it was not communicating with Sharpcap at the time.

Here is the log file. Thanks

https://internetsearchtechnologies.com/ ... -10224.log

Re: PHD2 says is guiding but Sharpcap says paused

Posted: Fri Apr 18, 2025 2:00 pm
by yomamma
Sorry wrong log file posted above. this one is correct

https://internetsearchtechnologies.com/ ... 2-3900.log

Re: PHD2 says is guiding but Sharpcap says paused

Posted: Sat Apr 19, 2025 2:12 pm
by admin
Hi,

I think what happened is that one of the limits (time or approach to meridian) expired while the sequence was in guiding pause mode, and it looks like the resume wasn't properly handled in that case, so that when the sequence continued on with the next section, the internal flag that says 'the guiding is currently paused' was still set.

I will fix that for the next update - hopefully that will resolve the issue.

cheers,

Robin

Re: PHD2 says is guiding but Sharpcap says paused

Posted: Sat Apr 19, 2025 8:30 pm
by yomamma
Thanks.
I ran the same script the next night and it worked fine.

Re: PHD2 says is guiding but Sharpcap says paused

Posted: Fri Apr 25, 2025 5:05 pm
by FEObs
I encountered a similar message last night while running calibration assistant in Phd2. The looping image would, from time to time blink to a homogenous colour of oxblood red (no star, no noise,no picture) lasting only a fraction of a second but that triggered the error banner that SharpCap says guiding is paused but Phd2 keeps rolling along. Its like the connection blinked out.

I have not experienced this in any other function of SharpCap or any other program.

FEobs
Jimmy

Re: PHD2 says is guiding but Sharpcap says paused

Posted: Sat Apr 26, 2025 7:04 pm
by admin
Hi,

SharpCap responds to messages that PHD2 sends during guiding - things like 'star lost' or 'guiding started' etc. It would be interesting to see the log from your session with the above problem (and if you could give me the time it happened too so I know where in the log to look!). There may be a sequence/ordering of the messages coming from PHD2 that doesn't match what SharpCap expects leading to this sort of problem.

cheers,

Robin