SharpCap Forums

This is a minor issue but it would be nice if it was fixed. When i open up the Sequencer Window and run a sequence, the log is updated in the lower right part of the window. If the Sequencer window is maximised, I can see the last entry in the log. All is good.

The bug occurs when I reduce the size of the window (such as you can). The log is not shown properly - i do not see the last entry in the log. Consequently, when i am checking how a sequence is running, i have to have the window at full size. This makes it hard to view info in the main SharpCap window (such as the status bar where frame saves and plate-solves are notified, or the time to end of frame counter (lower right corner)).

I am using the latest version of SharpCap.

Hi,

thanks for the report - I see the same when the window height is close to the minimum height allowed - should be easy to fix, so have a go with the next update and hopefully all will be fine

cheers,

Robin

Thanks Robin.