Page 1 of 1
Polar Alignment Questions.
Posted: Sun Jun 02, 2024 7:06 pm
by Victory Pete
I finally used the Polar Alignment routine last night and I did get a good alignment, but I have 2 issues. How do I minimize the instruction screen? The options in the upper right corner don't make any sense to me. Once I "minimize" the screen I can never get it back. Also, what does this message mean?

Re: Polar Alignment Questions.
Posted: Mon Jun 03, 2024 12:49 pm
by admin
Hi,
in the screenshot above, the polar alignment instructions look as though they have been set to auto-hide by using the 'pin' in the top right corner to unpin them. In this situation, hover your mouse over where it says 'Polar Align' at the bottom left and they should re-appear. Once they have re-appeared you can use the pin again to re-pin them so that they are no longer 'auto hide'.
The message shown about rotation during adjustment stage means that SharpCap has detected rotation of the RA axis after you have pressed the 'Next' button to move to the final, adjustment, stage of the polar alignment process. Rotating the RA axis while you are adjusting will lead to incorrect results, so SharpCap shows this warning/error and stops giving adjustment guidance if it is detected. If you had already completed the adjustment and were then putting the mount back to the home position in RA then you can ignore the warning, since your polar alignment work is already done.
cheers,
Robin
Re: Polar Alignment Questions.
Posted: Mon Jun 03, 2024 4:11 pm
by Victory Pete
Hi Robin
I am still not sure how to use this minimize function. I have tried over and over to make it come and go and it just doesn't make sense to me and certainly is not intuitive. I am not sure when I saw that Warning, I will see what happens next time I adjust.
VP