I've been working on some scripts for Siril that, in part, use the SET-TEMP from the FITS header of the images acquired with NINA and APT. Would it be possible to have that SET-TEMP written to the FITS header with SharpCap as well? The value is the temperature set, not the actual temperature of the sensor like CCD-TEMP.
Thanks!
Add SET-TEMP to FITS Header
Forum rules
'+1' posts are welcome in this area of the forums to indicate your support for a particular feature suggestion. Suggestions that get the most +1's will be seriously considered for inclusion in future versions of SharpCap.
'+1' posts are welcome in this area of the forums to indicate your support for a particular feature suggestion. Suggestions that get the most +1's will be seriously considered for inclusion in future versions of SharpCap.
- admin
- Site Admin
- Posts: 13529
- Joined: Sat Feb 11, 2017 3:52 pm
- Location: Vale of the White Horse, UK
- Contact:
Re: Add SET-TEMP to FITS Header
Hi,
yes, that should be possible - extra FITS headers are usually easy
cheers,
Robin
yes, that should be possible - extra FITS headers are usually easy
cheers,
Robin
-
- Posts: 4
- Joined: Fri Jun 09, 2023 11:09 pm
Re: Add SET-TEMP to FITS Header
Great! Thank you!
I'm going to push my luck here, but could we also get OFFSET added as well? I know that's what BLKLEVEL is, but OFFSET would help in keeping the scripts the same regardless of the acquisition software used.
I'm going to push my luck here, but could we also get OFFSET added as well? I know that's what BLKLEVEL is, but OFFSET would help in keeping the scripts the same regardless of the acquisition software used.
- admin
- Site Admin
- Posts: 13529
- Joined: Sat Feb 11, 2017 3:52 pm
- Location: Vale of the White Horse, UK
- Contact:
Re: Add SET-TEMP to FITS Header
Ok, that's not too hard either.
cheers,
Robin
cheers,
Robin