SC4.1 64 functionality with Non MoveAxis Ascom Driver
Posted: Mon Nov 13, 2023 11:12 am
Hi
I like to use your wonderful new mosaic tool for sun and moon imaging.
So I tested the SC4.1 version and realized that my ASCOM driver AdvancedLX200 Telescope/ FS2 Controller Mount and its combinations with Generic Hub, Poth Hub and the TheSky6/non GPS Meade LX200 are not functional because of the MoveAxis commands coming from the SC4.1. They are never recognized... Bad luck.
My Driver AdvancedLX200 Telescope directly linked to SC4.1 offers high lighted arrows in the guider command screen, but when I tick them the driver crashes with the hint move axis is not supported. Only the right arrow allows a short time movements but than it stops also with the same error. ticking the guide box start guiding?! but the selection of the type as sun, moon,... is not possible.
My questions:
1. Is it still possible that the SC4.1 succesfully uses the AdvancedLX200 Telescope driver for the pointing of mosaic targets or autocorrections? Or is the Move Axis command always involved in those guiding routines?
2. In order to set the 3 calibration points I may use the controller instead of the arrows to approach the right points. Is this possible as a work around?
3. Is it possible to implement an option +/- move axis commands like the FireCapture Programm 64 offers? In the software my AdvancedLX200 Telescope works nicely when the moveaxis command option is not selected.
Thank you very much indeed and kind regards Christoph
I like to use your wonderful new mosaic tool for sun and moon imaging.
So I tested the SC4.1 version and realized that my ASCOM driver AdvancedLX200 Telescope/ FS2 Controller Mount and its combinations with Generic Hub, Poth Hub and the TheSky6/non GPS Meade LX200 are not functional because of the MoveAxis commands coming from the SC4.1. They are never recognized... Bad luck.
My Driver AdvancedLX200 Telescope directly linked to SC4.1 offers high lighted arrows in the guider command screen, but when I tick them the driver crashes with the hint move axis is not supported. Only the right arrow allows a short time movements but than it stops also with the same error. ticking the guide box start guiding?! but the selection of the type as sun, moon,... is not possible.
My questions:
1. Is it still possible that the SC4.1 succesfully uses the AdvancedLX200 Telescope driver for the pointing of mosaic targets or autocorrections? Or is the Move Axis command always involved in those guiding routines?
2. In order to set the 3 calibration points I may use the controller instead of the arrows to approach the right points. Is this possible as a work around?
3. Is it possible to implement an option +/- move axis commands like the FireCapture Programm 64 offers? In the software my AdvancedLX200 Telescope works nicely when the moveaxis command option is not selected.
Thank you very much indeed and kind regards Christoph