SharpCap Forums

Posted: **Sun Apr 02, 2023 5:26 pm**

Dear all

Not so long ago I've read a post on a forum regarding the possiblity to specify gain values for the Sensor Analysis, kind of changing a config file. I can't find it and I've searched the forum with no luck.
Is this possible ?

Best regards

Ricardo

Posted: **Mon Apr 03, 2023 1:43 pm**

Hi Ricardo,

yes, you can do this via the scripting console. The command is

Code: Select all

SharpCap.SelectedCamera.SetGainsOfInterestForSensorAnalysis([79,80,81])

Obviously replace 79,80,81 with the values you are interested in. Run this command once you have opened the camera, but before you do the analysis. Note that the values are not remembered when you close and then re-open SharpCap.

cheers,

Robin

Posted: **Mon Apr 03, 2023 3:51 pm**

Thanks for the information Robin!

Best regards

Ricardo

SharpCap Forums

Set specific gain values for Sensor Analysis

Set specific gain values for Sensor Analysis

Re: Set specific gain values for Sensor Analysis

Re: Set specific gain values for Sensor Analysis