Flats typically are made with all the same settings as your lights except for exposure times. Only darks are needing the exact same settings as your lights.
Depending on your filters used, flats are generally short in exposure times. My flats are in general between 2sec to 8sec.
To come to this I play around with both my flat panel brightness and exposure times until I get around 25000 ADU (or when you are using the white T-shirt methode, add or remove fabric layers).
To see the ADU value, you have to open the Histogram. In the screenshot below I circled the ADU value in green on the right. Did search a little bit and I did see that other people with that same camera are using around 20000 ADU.
About the dust: it can be on anything that is in your image train. Dust on your scope lens can do no harm, that will not give any troubles in general. But it can never do any harm to blow it away of course.
But dust on your filters, protective glass, corrector/flattener, barlow, and so on, will.
And here a general rule when it comes to dust: the sharper and smaller the particle appears, the closer it is to your camera sensor.
So in this case the dust is faint and big, meaning it far away from your sensor. So somewhere at the beginning of your image train. When the dust specs are showing small and sharp, they are most likely on the protective window.
And yes, it can be a kind of battle to understand it all and get it right. When I was learning about calibrations files, I was getting frustrated because it looked like each thing I changed, affected another thing. Until I understood the balance of it all.
Hope this helps a bit.
Menno

- ADU flats.jpg (292.06 KiB) Viewed 2366 times