SharpCap Forums

I am trying to setup a sequence that will wait until NauticalDusk, then open a camera and associated profile, and start a SER capture that continues until Nautical Dawn.

I get an error stating

"Could not parse: START CAPTURE' while running step Start Capturing now and then stop when NauticalDawn occurs

I have attached a screenshot of the Sequence Editor.

Thanks!

Bryan

P.S. I started a new thread as the thread on Autostart sequence works fine...the problem is my sequence.

Hi Bryan,

sounds like a bug my side - I will investigate when I am back from my current trip away.

I think you could work around this - use separate steps for Start Capture, Wait until Nautical Dawn, Stop Capture - hopefully that will work.

thanks,

Robin