SV SV405CC Driver
-
- Posts: 13
- Joined: Fri Jun 10, 2022 7:11 am
SV SV405CC Driver
Help please: Sv405Cc. The native driver won't update beyond 1.6.3. I've uninstalled 1.6.3, and installed 1.7.3 and Nina still reports 1.6.3. I then used the SDK file and dropped the .DLL file into the Nina folder and it now reports 1.7.3. However Sharpcap is still using the 1.6.3 driver and the sensor analysis doesn't work properly. Does anyone have a solution to this, how is the 1.7.3 NATIVE driver installed so that both Nina and Sharpcap use the latest driver?
- admin
- Site Admin
- Posts: 13330
- Joined: Sat Feb 11, 2017 3:52 pm
- Location: Vale of the White Horse, UK
- Contact:
Re: SV SV405CC Driver
Hi,
the last few updates to SharpCap 4 have SVBony SDK 1.7.3 in them - make sure you have version 4.0.9094 or later.
I also now have version 1.8.1 here - it will be in next week's SharpCap update, so check out the downloads page on Monday (evening, UK time).
cheers,
Robin
the last few updates to SharpCap 4 have SVBony SDK 1.7.3 in them - make sure you have version 4.0.9094 or later.
I also now have version 1.8.1 here - it will be in next week's SharpCap update, so check out the downloads page on Monday (evening, UK time).
cheers,
Robin
-
- Posts: 13
- Joined: Fri Jun 10, 2022 7:11 am
Re: SV SV405CC Driver
Hi, Thanks. I've just updated again, I didn't realise that a manual download and update was required in Sharpcap to take this. I am running a new sensor analysis now. I have been testing this camera for a few weeks and I hope his driver version has the HGC as the other drivers didn't show it. Thanks.
- admin
- Site Admin
- Posts: 13330
- Joined: Sat Feb 11, 2017 3:52 pm
- Location: Vale of the White Horse, UK
- Contact:
Re: SV SV405CC Driver
Hi,
the auto-updates typically run between a few weeks and a couple of months behind the manual updates - I wait until I have a version that looks 'good' from the point of view of no major issues before setting up a new auto-update.
I think 1.7.3 should add HCG - the change notes for that version read as follows
However I don't know if the HCG switch over is manual (in which case it may not be available) or if it is built into the gain control as with ZWO cameras.
cheers,
Robin
the auto-updates typically run between a few weeks and a couple of months behind the manual updates - I wait until I have a version that looks 'good' from the point of view of no major issues before setting up a new auto-update.
I think 1.7.3 should add HCG - the change notes for that version read as follows
Code: Select all
1. Fixed the problem of unstable temperature control of SV405CC
2. Fixed the first frame timeout problem of SV405CC soft trigger
3. Modify the maximum gain of SV405CC to 57dB, and add the HCG gain control
cheers,
Robin