SharpCap Forums

How do i change the default advanced sequence program to one that i have set up, so i dont have to load it ?
Thanks
Tim

Hi Tim,

by default the sequencing engine reloads the last sequence you used. You can also use the Sequencer->Run Recent menu to pick from one of the saved sequences that you have recently used.

cheers,

Robin

Hi Robin,
I see the Run Recent... selection, but this doesnt put into into the editor. How do i change the default program to edit? (which should have been my question!) For the sequence to work i need to change the start time and duration. There is no problem to load it, but since there is a sequence pre-loaded, i thought i might change that to my own. I havnt found how to do that.
Thanks

Hi,

ah, I see.

No real way to do that - the one that is pre-loaded is the one that you were using most recently, based on the idea that (a) you might want to go back to where you left off and (b) not losing anything if you close without saving.

cheers,

Robin