Control of SKywatcher az-eq5 in alt/az mode
Posted: Wed Jan 12, 2022 8:54 am
Hello ,
I would like to use sharpcap to control my mount in alt/az mode. I have installed the skywatcher ascom drivers and i was able to slew the mount.
But when i tried to run platesolving and sync with the mount i had no success.
Ideally i would like to use this mount for electronic assisted astronomy so being able to operate it in alt/az mode will greatly speed up the process.
Is there any tutorial available for setting up sharpcap for controlling mounts in alt/az ?
connect to mount, plate solve sync and then i will switch to live stacking.
Looking forward for your feedback on this.
Kind regards,
Kle
I would like to use sharpcap to control my mount in alt/az mode. I have installed the skywatcher ascom drivers and i was able to slew the mount.
But when i tried to run platesolving and sync with the mount i had no success.
Ideally i would like to use this mount for electronic assisted astronomy so being able to operate it in alt/az mode will greatly speed up the process.
Is there any tutorial available for setting up sharpcap for controlling mounts in alt/az ?
connect to mount, plate solve sync and then i will switch to live stacking.
Looking forward for your feedback on this.
Kind regards,
Kle