Still struggling with some settings...
Posted: Mon Dec 27, 2021 4:32 pm
Hi everyone,
after a couple of weeks, I could run a session overnight and could capture various objects. I'm still struggling with the right settings of the cam and hope to get some hints and tips.
As an example, I have taken one of the images. M74 - Phantom Galaxy.
My setup in this case is a TS Photoline 60/360, a Neptune-C, Skywatcher LPR, iOptron Cube Pro (Alt/AZ mode).
Sharpcap 4.0 / 32bit (latest version) - Livestack
At the beginning, I took 10 Darks with the same parameter as used during the session. Exp 15 sec, Gain 400, Offset 150.
Livestack in Default setting.
FWHM was between 4.5 - 5.5. Focusing was done before with a Bahtinov mask.
I captured 300 frames (unfortunately, but for some reasons, I didn't store the individual frames).
Attached is a screenprint of the resulting fits-file.
After an initial stretching with ASIFitsviewer and processing with Astrosurface and Fitswork I've got eventually an acceptable image.
However, looking on the fits file, it seems to me very noisy, as well as banding is present. On the right hand side, there are still remains of ampglow.
What should I do different the next time. Thx a lot in advance, regards and always CS
Gottfried
after a couple of weeks, I could run a session overnight and could capture various objects. I'm still struggling with the right settings of the cam and hope to get some hints and tips.
As an example, I have taken one of the images. M74 - Phantom Galaxy.
My setup in this case is a TS Photoline 60/360, a Neptune-C, Skywatcher LPR, iOptron Cube Pro (Alt/AZ mode).
Sharpcap 4.0 / 32bit (latest version) - Livestack
At the beginning, I took 10 Darks with the same parameter as used during the session. Exp 15 sec, Gain 400, Offset 150.
Livestack in Default setting.
FWHM was between 4.5 - 5.5. Focusing was done before with a Bahtinov mask.
I captured 300 frames (unfortunately, but for some reasons, I didn't store the individual frames).
Attached is a screenprint of the resulting fits-file.
After an initial stretching with ASIFitsviewer and processing with Astrosurface and Fitswork I've got eventually an acceptable image.
However, looking on the fits file, it seems to me very noisy, as well as banding is present. On the right hand side, there are still remains of ampglow.
What should I do different the next time. Thx a lot in advance, regards and always CS
Gottfried