Page 1 of 1
Setting up PLatesolver
Posted: Thu Aug 05, 2021 8:42 am
by woldsweather
I am trying to move from SC3.2 to SC4. I have all sky platesolver installed on my windows 10 laptop but when I go to SC settings>Plaetsolver it's not in the list. How can I get it yo show?
Re: Setting up PLatesolver
Posted: Thu Aug 05, 2021 1:31 pm
by admin
Hi,
have a look at the bottom of the plate solving settings page - it gives a detection status for each engine
- Capture.JPG (33.48 KiB) Viewed 488 times
SharpCap not only checks for the application being installed, but also that it can find some index files and that the application seems to be configured correctly. This is relatively new, so may not pick things up correctly if you have a non-standard install of ASPS. Anyway, hopefully the status will give some clues as to why SharpCap is not spotting ASPS.
cheers,
Robin
Re: Setting up PLatesolver
Posted: Thu Aug 05, 2021 1:35 pm
by woldsweather
I've installed Astap now as mine said the same as your below re ASPS