goto target timeout
Posted: Sat Jul 10, 2021 8:41 pm
HI
I had my first experience with the sequencer, and I tested a slew to a target, over 30-40 degrees. My mount is probably peculiar, because for several reasons I slowed down the goto speed. In my test, it took just over 60 seconds, enough to receive the error message:
"Mount failed to complete goto within 60 seconds"
which makes the sequencer immediately fail. Is there a possibility to tune the timeout value? I did not find it, but it would be very useful.... and would solve my problem!
best regards
Paolo
I had my first experience with the sequencer, and I tested a slew to a target, over 30-40 degrees. My mount is probably peculiar, because for several reasons I slowed down the goto speed. In my test, it took just over 60 seconds, enough to receive the error message:
"Mount failed to complete goto within 60 seconds"
which makes the sequencer immediately fail. Is there a possibility to tune the timeout value? I did not find it, but it would be very useful.... and would solve my problem!
best regards
Paolo