M51 plus and minus HA
Posted: Sun Feb 14, 2021 5:55 pm
Took advantage of a couple of weather gaps to capture RGB galaxy images at long focus (f = 1000mm) around the new moon (13/02) - and HA in a clearsky gap earlier in January.
Skywatcher 200 PDS Newtonian F 5.0 plus Baader field flattener
Ioptron CEM70 mount
PHD2 guiding via 10 x 50 finder and ASI 120mm
Pegasus Cube focuser
ASI 294 MC PRO for RGB images at -10C
ASI 294 MM PRO and Optolong 7 nm HA filter for HA images at -10C
Gray-scale flats (100 frames) and darks (40 frames) at -10 C created by SC
160 x 40s (106 min) RGB images -(total accepted after many rejected by the SC filters and then a few more by PixInsight)
9 x 180s HA images
Gain 124, offset 10
Bortle 6 skies
Preprocessing and postprocessing in Pixinsight (DBE, Photometric colour calibration, pixelmath, MLT, Histransform, Curves) and tidied up in Affinity.
The image on the left is without addition of the H alpha. A balanced HA - red channel difference image was added back to the red channel to create the image on the right. The HA nicely shows up the very high rate of star formation going on in M51 - presumptively due to the disruption of the spiral arms due to the relatively recent passage of the associated galaxy, NGC 5195. I also like the fact that the HA signal removes any ambiguity about which points of light are associated with the galaxy and which are foreground stars. A couple at least that I would have taken to be foreground are actually massively bright HA regions seen at some 23 M ly. Must be a good galaxy to live in for spectacular deep sky astronomy!
For galaxy images is interesting to note at which point hubble red shift (plus any local recessional velocity) will move the HA signal outside of the bounds of the filter. My 7 nm filter should be OK out to about 100 M ly but beyond that a wider bandwidth filter or even an SII filter might be called for?
Tim
Skywatcher 200 PDS Newtonian F 5.0 plus Baader field flattener
Ioptron CEM70 mount
PHD2 guiding via 10 x 50 finder and ASI 120mm
Pegasus Cube focuser
ASI 294 MC PRO for RGB images at -10C
ASI 294 MM PRO and Optolong 7 nm HA filter for HA images at -10C
Gray-scale flats (100 frames) and darks (40 frames) at -10 C created by SC
160 x 40s (106 min) RGB images -(total accepted after many rejected by the SC filters and then a few more by PixInsight)
9 x 180s HA images
Gain 124, offset 10
Bortle 6 skies
Preprocessing and postprocessing in Pixinsight (DBE, Photometric colour calibration, pixelmath, MLT, Histransform, Curves) and tidied up in Affinity.
The image on the left is without addition of the H alpha. A balanced HA - red channel difference image was added back to the red channel to create the image on the right. The HA nicely shows up the very high rate of star formation going on in M51 - presumptively due to the disruption of the spiral arms due to the relatively recent passage of the associated galaxy, NGC 5195. I also like the fact that the HA signal removes any ambiguity about which points of light are associated with the galaxy and which are foreground stars. A couple at least that I would have taken to be foreground are actually massively bright HA regions seen at some 23 M ly. Must be a good galaxy to live in for spectacular deep sky astronomy!
For galaxy images is interesting to note at which point hubble red shift (plus any local recessional velocity) will move the HA signal outside of the bounds of the filter. My 7 nm filter should be OK out to about 100 M ly but beyond that a wider bandwidth filter or even an SII filter might be called for?
Tim