SharpCap Forums

Posted: **Tue Feb 28, 2017 7:17 pm**

When I start SharpCap (2.10.3600) my USB_Focus V3 Focuser (http://www.usb-foc.us/, ASCOM driver v2.64) is connected, and apparently works well.
However, before closing SharpCap, I MUST uncheck the “Connected” selection box in the Focuser control panel (see enclosed picture).

: Connected.JPG (19.06 KiB) Viewed 3153 times

If I leave the “Connected” box checked, the focuser cannot be connected any more. If I restart SparpCap I get an error message (see figure below).

Posted: **Tue Feb 28, 2017 8:35 pm**

Ok, thanks for the report - I can understand what is happening here - SharpCap is not disconnecting the focuser correctly on shutdown which somehow leaves the serial port open so that it cannot be used the next time. I will put it on the to-fix list for 2.10

cheers,

Robin

Posted: **Sat Mar 11, 2017 4:22 pm**

This problem has been solved in SharpCap 2.10.3649

Posted: **Sat Mar 11, 2017 8:32 pm**

Good, I was expecting it to be fixed.

cheers,

Robin

SharpCap Forums

Connection problem of USB_Focus focuser

Connection problem of USB_Focus focuser

Re: Connection problem of USB_Focus focuser

Re: Connection problem of USB_Focus focuser

Re: Connection problem of USB_Focus focuser