Page 1 of 1

Plate Solving - Quick Question

Posted: Sat Nov 07, 2020 6:44 pm
by GaryS
Hi,

When I go to plate solve after a slew, I often, perhaps always, notice the phrase: "down sampling by 2". Could someone please explain what this means and whether I may need to change the default Astrotortilla UI settings. I've seen posts that outline custom settings to enter into Astrotortilla but I have never changed the defaults except to limit solution attempts to a 15 degree radius since SC declares failure if the slew is more than that far off.

Thank you for any help and advice you can offer. I'm just hoping to better understand the plate solving process that goes on.

Gary

Re: Plate Solving - Quick Question

Posted: Sat Nov 07, 2020 7:06 pm
by admin
Hi,

experience has helped us understand that the engine used for plate solving in AstroTortilla, ASPS and AnSvr is actually not very good for very high resolution images for some reason. In order to improve the reliability of plate solving SharpCap will ask the engine to reduce the resolution if the image width exceeds (from memory) 2000 pixels. This is basically equivalent to binning the image – with the binning factor chosen depending on the width and height of the image in pixels.

Cheers, Robin

Re: Plate Solving - Quick Question

Posted: Sat Nov 07, 2020 8:57 pm
by GaryS
Ok Robin thank you. Since the solver is solving based on stars, what ‘image’ is the binning being based on?

Posted: Sun Nov 08, 2020 3:33 pm
by admin
Hi,

it's the size of the image (in pixels) coming off the camera.

If the camera image width is 1 to 2000 pixels then now downscaling is applied
2001 to 4000 then the factor is 2
4001 to 6000 then a factor of 3 and so on.

thanks,

Robin