Hi folks,
Currently I am using the Sharpcap measurement of FWHM (which I understand to be in pixels) to decide whether or not I should BIN and go for better signal to noise rather than resolution - i.e. I tend to stick with 1x1 unless FWHM goes up above about 4.5 - at which point I 2x" BIN.
But what does the Sharpcap FWHM value mean at 2x2? Does the value still refer to the original pixel size or to the new virtual 2x2 big pixels? Should I be expecting to see much lower FWHM scores at 2x2 binning?
Grateful for comments on this
best wishes
Tim
Binning and the Sharpcap measurement of FWHM?
- admin
- Site Admin
- Posts: 17576
- Joined: Sat Feb 11, 2017 3:52 pm
- Location: Vale of the White Horse, UK
- Contact:
Re: Binning and the Sharpcap measurement of FWHM?
Hi,
the FWHM measurements don't make any special allowances for the binning setting – they just count the size of the star in terms of pixels in the image that is going to be saved. That means that if you have an FWHM of five at binning 1, you will get a value of about 2 to 3 if you switch to binning 2.
Hope this helps, Robin
the FWHM measurements don't make any special allowances for the binning setting – they just count the size of the star in terms of pixels in the image that is going to be saved. That means that if you have an FWHM of five at binning 1, you will get a value of about 2 to 3 if you switch to binning 2.
Hope this helps, Robin
Re: Binning and the Sharpcap measurement of FWHM?
Thanks very much Robin. That makes perfect sense