3.2 does not remember my last screen location after closing and opening
Posted: Wed Sep 11, 2019 4:43 pm
Hello,
I am new to SharpCap, but I've noticed that every time I close and reopen SharpCap it does not go back to the same screen location.
I would like a way to have it go back to the same screen location because I end up opening up my SynScan app and wish to have it set to the right of the non-full screen version of the app.
Repro:
1) Open up SharpCap Pro 3.2
Notice; It opens full screen
2) Adjust the app so that there is a right hand gap for enough space to hold SynScan app
3) Close SharpCap
4) Re-open SharpCap
Notice: SharpCap opens full screen and does not remember the last setup.
Expect: that ShpareCap remembers the last setup.
If this could be fixed, that would be sweet as I would not have to reset the screen location every time I open the app.
It's a small thing, but it feels a little odd that I have to do it every tie I open the app.
Thanks,
Brett
I am new to SharpCap, but I've noticed that every time I close and reopen SharpCap it does not go back to the same screen location.
I would like a way to have it go back to the same screen location because I end up opening up my SynScan app and wish to have it set to the right of the non-full screen version of the app.
Repro:
1) Open up SharpCap Pro 3.2
Notice; It opens full screen
2) Adjust the app so that there is a right hand gap for enough space to hold SynScan app
3) Close SharpCap
4) Re-open SharpCap
Notice: SharpCap opens full screen and does not remember the last setup.
Expect: that ShpareCap remembers the last setup.
If this could be fixed, that would be sweet as I would not have to reset the screen location every time I open the app.
It's a small thing, but it feels a little odd that I have to do it every tie I open the app.
Thanks,
Brett