Polar alignment with Lodestar x2 mono guide camera
Posted: Mon May 20, 2019 2:59 pm
I'm planning to use Sharpcap mainly for Polar alignment using a Starlight Express Lodestar X2 mono guide camera, combined with a William Optics 200mm FL x 50mm guide scope, which I calculate provides a FOV of 1.85 x 1.38 degrees. I've been using this set-up successfully with PHD2 for sometime.
Given the above parameters + before proceeding any further with Sharpcap Pro I want to confirm:
1. Will the pixel size of 8.6 x 8.3 nm, which is not square, work OK with Sharpcap and plate solving, which I understand is an integral part of the polar alignment routine?
2. Is the FOV OK?
3. Will the installed ASCOM driver for this camera which I use with PHD2 be OK with Sharpcap or do I need something else - if so which one?
Thanks, Graham
Given the above parameters + before proceeding any further with Sharpcap Pro I want to confirm:
1. Will the pixel size of 8.6 x 8.3 nm, which is not square, work OK with Sharpcap and plate solving, which I understand is an integral part of the polar alignment routine?
2. Is the FOV OK?
3. Will the installed ASCOM driver for this camera which I use with PHD2 be OK with Sharpcap or do I need something else - if so which one?
Thanks, Graham