Sync failure after plate solve
Posted: Fri Sep 14, 2018 6:01 am
I've been having difficulty with the purported sync after plate solve function. I am using a Celestron AVX mount together with Stellarium and Stellariumscope to get all the devices trying to communicate with the mount to play nicely together. Stellarium can read the mount RA/DEC values and can slew the mount correctly.
I've installed Astrotortilla and I can run the plate solve utility in Sharpcap and it does successfully resolve the plate and gives me the RA/DEC values for the current screen capture. What it does not do is slew the mount. I have selected the 'Celestron telescope driver' in the hardware tab and Sharcap does prompt that the amount is already connected (by virtue of Stellariumscope) if I try and open the properties tab.
I've also tried do this without Stellarium and then select COM6 in the Celestron set-up dialogue box under properties to see if that makes a difference but it does not. I can't seem to get Sharpcap to slew the AVX mount no matter what I do.
I'm sure that I'm doing something stupid but whatever it is, it has thus far evaded me. Any suggestions would be greatly appreciated!!
I've installed Astrotortilla and I can run the plate solve utility in Sharpcap and it does successfully resolve the plate and gives me the RA/DEC values for the current screen capture. What it does not do is slew the mount. I have selected the 'Celestron telescope driver' in the hardware tab and Sharcap does prompt that the amount is already connected (by virtue of Stellariumscope) if I try and open the properties tab.
I've also tried do this without Stellarium and then select COM6 in the Celestron set-up dialogue box under properties to see if that makes a difference but it does not. I can't seem to get Sharpcap to slew the AVX mount no matter what I do.
I'm sure that I'm doing something stupid but whatever it is, it has thus far evaded me. Any suggestions would be greatly appreciated!!