Mismatch between SharpCap and PHD2 polar error
Posted: Mon Jul 16, 2018 4:50 pm
Hi
I have been using the Polar alignment feature for a while now and love it. Like many here I can easily get to within 5 arc seconds and Excellent with a bit of careful adjustment - Polaris is not in the FOV I'm pretty sure its not anyway so there is some cone error that may need sorting - I think you said that a few degrees is OK so I hope that is all it is on my setup. How critical is it to get good polar alignment if the route runs smoothly every time and I can get really close according to Sharpcap.
When I run PHD2 the calculated polar error seems to always be quite a bit higher than that reported by Sharpcap - any reasons why this might be?
I have tried to get everything lined up - took the head off the tripod mount on the HEQ5 Pro and levels it - the bubble on the head when reattached was way out so hopefully the mount is level (is this important or only a nice to have?)
Is there anything else that is critically important (I take note of the flex issue but everything is locked up tight.
Regards
Dave
I have been using the Polar alignment feature for a while now and love it. Like many here I can easily get to within 5 arc seconds and Excellent with a bit of careful adjustment - Polaris is not in the FOV I'm pretty sure its not anyway so there is some cone error that may need sorting - I think you said that a few degrees is OK so I hope that is all it is on my setup. How critical is it to get good polar alignment if the route runs smoothly every time and I can get really close according to Sharpcap.
When I run PHD2 the calculated polar error seems to always be quite a bit higher than that reported by Sharpcap - any reasons why this might be?
I have tried to get everything lined up - took the head off the tripod mount on the HEQ5 Pro and levels it - the bubble on the head when reattached was way out so hopefully the mount is level (is this important or only a nice to have?)
Is there anything else that is critically important (I take note of the flex issue but everything is locked up tight.
Regards
Dave