Smart histogram and "Total Stacking Time"

Anything that doesn't fit into any of the other forums
Post Reply
hindsight2020
Posts: 4
Joined: Mon Mar 31, 2025 12:22 pm

Smart histogram and "Total Stacking Time"

#1

Post by hindsight2020 »

In reading the documentation on Smart Histogram, I noticed this statement, "Note that the primary results (suggested exposure length and gain) do not change if you select longer or shorter total stacking times than the default value of 60 minutes."

I am trying to understand why that is. Wouldn't the suggested exposure length and gain need to change if the total stacking time is much more than 60 minutes? What is the purpose of this field if it doesn't change the results?

Thank you.
User avatar
admin
Site Admin
Posts: 17580
Joined: Sat Feb 11, 2017 3:52 pm
Location: Vale of the White Horse, UK
Contact:

Re: Smart histogram and "Total Stacking Time"

#2

Post by admin »

Hi,

The suggested camera settings really only depend on the sky brightness (which in turn depends on light pollution, filters and f-ratio) and the read noise (which comes from the gain). I suppose that if you set a total stacking time of 5 minutes and the calculation for sub-exposure length came out at 9 minutes then there is a bit of a contradiction, but you are realistically not going to image a target that requires long subs for just 10 or 20 minutes in total, so in practice that doesn't matter.

What the total stacking time does affect is

* The number of sub exposures that will need to be captured (total stacking time divided by exposure) - that number is shown because if it starts to head up into the high hundreds or even thousands, you might want to increase exposure just to keep the amount of data under control

* The brightness of the faintest detectable detail according to the Detection Threshold Simulation (third tab along in the graphs). If you change the total stacking time from 1h to 4h, the value there should typically halve.

cheers,

Robin
hindsight2020
Posts: 4
Joined: Mon Mar 31, 2025 12:22 pm

Re: Smart histogram and "Total Stacking Time"

#3

Post by hindsight2020 »

Thanks for the quick reply and information Robin.
Post Reply