Hi Robin,
maybe you can please add a command to set tracking rate, Sideral/Lunar/Solar/King .. if available in mount.
CS
Thomas
Sequencer -> add Set Tracking Rate
Forum rules
'+1' posts are welcome in this area of the forums to indicate your support for a particular feature suggestion. Suggestions that get the most +1's will be seriously considered for inclusion in future versions of SharpCap.
'+1' posts are welcome in this area of the forums to indicate your support for a particular feature suggestion. Suggestions that get the most +1's will be seriously considered for inclusion in future versions of SharpCap.
- admin
- Site Admin
- Posts: 13483
- Joined: Sat Feb 11, 2017 3:52 pm
- Location: Vale of the White Horse, UK
- Contact:
Re: Sequencer -> add Set Tracking Rate
Hi Thomas,
that step already exists - it's in the 'Mount' section as 'Set Mount tracking rate to <...>'. You can also set the rate to 'None' using this step to disable tracking.
If you're not seeing it then you may need to update your version of SharpCap.
cheers,
Robin
that step already exists - it's in the 'Mount' section as 'Set Mount tracking rate to <...>'. You can also set the rate to 'None' using this step to disable tracking.
If you're not seeing it then you may need to update your version of SharpCap.
cheers,
Robin
-
- Posts: 19
- Joined: Wed Jun 22, 2022 1:06 pm
Re: Sequencer -> add Set Tracking Rate
Hi Robin,
Ah ok, yes it's now available, thanks.
It seems there is no interaction with ASCOM driver of mount to ask for available rates.
I can set King rate without any error message on a mount where there is none.
But I'm not sure if this is an issue of ACSOM driver for this mount, it may accept the command without an error message.
CS
Thomas
Ah ok, yes it's now available, thanks.
It seems there is no interaction with ASCOM driver of mount to ask for available rates.
I can set King rate without any error message on a mount where there is none.
But I'm not sure if this is an issue of ACSOM driver for this mount, it may accept the command without an error message.
CS
Thomas
- admin
- Site Admin
- Posts: 13483
- Joined: Sat Feb 11, 2017 3:52 pm
- Location: Vale of the White Horse, UK
- Contact:
Re: Sequencer -> add Set Tracking Rate
Hi Thomas,
yes, you're right - in the drop down for the sequencer it just lists all the possible rates without checking with the mount. As you say, you will get an error if you choose a rate not supported by your mount.
cheers,
Robin
yes, you're right - in the drop down for the sequencer it just lists all the possible rates without checking with the mount. As you say, you will get an error if you choose a rate not supported by your mount.
cheers,
Robin