Sequencer Wait until timing
Re: Sequencer Wait until timing
Solved my own issue, found the "Wait until later than <Time of Day>" command and that seems to be working! The sequence no longer stalls if it falls a bit behind!
- admin
- Site Admin
- Posts: 13473
- Joined: Sat Feb 11, 2017 3:52 pm
- Location: Vale of the White Horse, UK
- Contact:
Re: Sequencer Wait until timing
Hi,
yes, the wait until later step is there just for that sort of situation. I started out with only one wait step, but soon realised that two were necessary because the intention could be either 'get on with it if the time is already passed' or 'wait until the next day if the time is already passed'.
cheers, and good luck with the eclipse!
Robin
yes, the wait until later step is there just for that sort of situation. I started out with only one wait step, but soon realised that two were necessary because the intention could be either 'get on with it if the time is already passed' or 'wait until the next day if the time is already passed'.
cheers, and good luck with the eclipse!
Robin