Cannot Connect or Configure Focuser
Posted: Thu Sep 12, 2019 12:27 am
My focuser, a Robofocus, which worked previously with SharpCap is no longer connecting. I can use the native Robofocus utility just fine, but I had to remove it from my hardware config in SharpCap because it kept throwing an error whenever I connected my camera or changed cameras.
When I go to configure my hardware, I attempted to set the properties of the Robofocus, but when I click on the Properties button I get an error.
"An error occurred while trying to show properties...."
Attached is the log file showing such a situation.
When I go to configure my hardware, I attempted to set the properties of the Robofocus, but when I click on the Properties button I get an error.
"An error occurred while trying to show properties...."
Attached is the log file showing such a situation.