Sensor Analysis for QHY168c
Posted: Sun Jun 10, 2018 12:59 am
Hello,
I am trying to calibrate my QHY168c and I think I might be running into a bug. What's happening is when I start the procedure, the RGB balance levels jump to their maximum value of 15 which creates all sorts of problems. (Typically, they are kept at the (rough) mid point level of 7. When they are at this level, everything looks fine although, I typically have to cut the green level down to 5.) When they jump to 15, everything becomes saturated and as expected, Sharpcap complains that the light level is too high. Is the balance supposed to jump like that during the calibration? Needless to say, I can't analyze the sensor.
Thanks,
-Gene
I am trying to calibrate my QHY168c and I think I might be running into a bug. What's happening is when I start the procedure, the RGB balance levels jump to their maximum value of 15 which creates all sorts of problems. (Typically, they are kept at the (rough) mid point level of 7. When they are at this level, everything looks fine although, I typically have to cut the green level down to 5.) When they jump to 15, everything becomes saturated and as expected, Sharpcap complains that the light level is too high. Is the balance supposed to jump like that during the calibration? Needless to say, I can't analyze the sensor.
Thanks,
-Gene