Hi,
During my upgrade to the latest version (3.2.6473) I found wrong gain settings for my QHY294M-pro (max 2045 instead of 3264) which I corrected by updating again from QHY drivers.
I point this out to you for a future version.
Regards
Dominique
SDK for QHY294M-pro
- admin
- Site Admin
- Posts: 13344
- Joined: Sat Feb 11, 2017 3:52 pm
- Location: Vale of the White Horse, UK
- Contact:
Re: SDK for QHY294M-pro
Hi,
thanks for the info - looks like they put out a new SDK version just after christmas which I didn't spot.
It will be in the next SharpCap 3.3 update (next Monday or thereabouts).
Robin
thanks for the info - looks like they put out a new SDK version just after christmas which I didn't spot.
It will be in the next SharpCap 3.3 update (next Monday or thereabouts).
Robin
Re: SDK for QHY294M-pro
Thanks Robin,
They have indeed released a new driver for the QHY294M-Pro following our comments on 12/28.
It is true that for my photoshoots I prefer to use version 3.2, but I also have 3.3 on which I am not too active on the test side because I do not plan to use the sequencer as is. Between the new camera (Mono) to master and Pixinsight which requires time to soak up the hours pass quickly.
I will upgrade from version 3.3 and check that the QHY294M-pro works properly with it.
Dominique
They have indeed released a new driver for the QHY294M-Pro following our comments on 12/28.
It is true that for my photoshoots I prefer to use version 3.2, but I also have 3.3 on which I am not too active on the test side because I do not plan to use the sequencer as is. Between the new camera (Mono) to master and Pixinsight which requires time to soak up the hours pass quickly.
I will upgrade from version 3.3 and check that the QHY294M-pro works properly with it.
Dominique
Dominique