qhycfw3 couldn't work with QHY183m in Sharpcap
Posted: Mon Dec 24, 2018 11:01 am
Since I bought the qhycfw3 last month, all the setting worked well in the EZ-CAP QT. But there are problems when I tried it in Sharpcap.
The qhycfw3 was connected to qhy183m with the 4-pin cable and the LED status was green.
All the drivers were updated. It didn't work wither in sharpcap edition 3.2.5892.0 or 3.2.5897.0.
When I connected all the cables, and open the sharpcap, connected qhy183m, a error message occurred. If I changed the hardware setting to QHYCCD FilterWheel, the other error occurred. I also tried USB mode to use in ASCOM driver (LED red), however, it still didn't work.
Could anyone help me? Thanks a lot.
The qhycfw3 was connected to qhy183m with the 4-pin cable and the LED status was green.
All the drivers were updated. It didn't work wither in sharpcap edition 3.2.5892.0 or 3.2.5897.0.
When I connected all the cables, and open the sharpcap, connected qhy183m, a error message occurred. If I changed the hardware setting to QHYCCD FilterWheel, the other error occurred. I also tried USB mode to use in ASCOM driver (LED red), however, it still didn't work.
Could anyone help me? Thanks a lot.